Email : Tel : +86 317 495 8921

Company News

Home > News > Company News

What Are The Requirements For Cable Protection Cable Chain?

Jul. 02, 2019

Here is Small Cable Chain China Manufacturer talking about What Are The Requirements For Cable Protection Cable Chain.

If you have any idea about Small Cable Drag Chain, welcome to contact us and discuss.

The use of cable protection towline began in Germany and was introduced to China and was continuously innovated. The cable protection towline is generally applied to cables, oil pipes, air pipes, water pipes and air ducts of machine tools, etc., and plays a role of traction and protection. There are three types depending on the environment and usage requirements: bridge chain, fully enclosed chain and semi-closed chain. In addition, each section of the cable protection towline can be opened for easy installation and maintenance. Low noise, wear resistance and high-speed movement during exercise.

Small Cable Drag Chain

1. The cable drag chain cable cannot be twisted, nor is it a cable from one end of the cable reel or the cable tray to one end. Instead, the reel or cable reel should be rotated first, and the cable can be unfolded or suspended if necessary. Cable use can only be obtained directly from the cable coil.

2. You need to pay attention to the minimum bending radius of the cable.

3. The cables in the chain cannot touch each other.

4. The two points of the cable chain should be fixed or fixed at the end of the movement of the chain. The moving point should be 20-30 times the diameter of the cable at the end of the chain.

5. If the chain is broken, the cable must be replaced, and the break due to excessive stretching is unavoidable.

6. The cables should be arranged neatly in the towline. They should be arranged separately. The partitions should be separated or separated by the partitions. The gap between the towline cables should be at least 10% of the cable diameter.

7. Make sure that the cable moves fully within the bend radius, ie it cannot be forced to move. This allows the cables to move relative to each other. In addition, after a period of operation, it is best to check the cable position. This check must be performed after the push-pull movement.